Gdog555
About
- Username
- Gdog555
- Joined
- Visits
- 22
- Last Active
- Roles
- No Roles
- Points
- 2
- Posts
- 3
- 1
- Badges
-
Cloned track with same synth
Hi,
After using the Deluge for a while, I’ve also discovered this unusual behaviour of cloned tracks......Load the 1st preset to track 1 & lower its cutoff; then clone this same preset to track 2 & raise its cutoff. Then I play these patterns consecutively in the Arranger view - The 1st pattern has a low cutoff, the 2nd has a high cutoff. Great! That means I can change everything in the clone track and it’s completely independent right!? Wrong! I try transposing the clone pattern & it effects the 1st too...
I agree with others that there should be 2 copy/clone modes - 1) all parameters are linked between patterns/clones. 2) all parameters are independent (unlinked) between patterns/clones.
Atm, it’s just too confusing to know what’s going to happen when cloning, so better to save/use a new preset per track
Thanks for reading 👍
-
Keyboard mode only 1 layout?
Thanks for the reply @Too_Mere 👍 & yes I already know I can move around with the arrow knobs 😺
Hopefully, the layout can be changed in the future, as it would allow for ~10 octave range! (A bit more than the ~4 atm!)
Thanks again 🙏