Lfo trem/pan assigned only to the tail release of ENV
Hi. In synth mode (multi-sample in my case) I can't assign an LFO (tremolo pan) only at the end of my note. So the tail of the release. I can do it with ENV2+ a vibrato and an LPF but not with my LFO/trem pan. Can anyone explain to me how to configure adsr correctly? Thanks a lot.
Best Answer
-
reza los angelesPosts: 611
it's a little complicated, but here's how to achieve it:
env1 set as needed. for this example, you obviously want some release:
A - 0
D - 20
S - 50
R - 40for env2 (what we are going to patch PAN to):
A - 0
D - 0
S - 25 (sustain is in the middle so PAN stays unchanged while holding down a note)
R - 0 to 50 (creates a fade into the tremolo the higher the number, try R-20 to start)the next part is where it gets a little harder to wrap your head around:
(PAN) patched to (ENV2): -50
(PAN -> ENV2) patched to (LFO2): 50 (control intensity of tremolo amount).
Note: LFO2 should blink blue instead of white for the last step. If you are using shortcuts, make sure to enter LFO2 shortcut while holding ENV2 (when PAN & ENV2 are both blinking) to modulate a modulation (blue blinking pad confirms).Post edited by reza on
Answers
Fantastic ! I will try it today. Thanks a lot.
Hi Reza. After few attempts It works. Thanks a lot.